T60 Curved Lead Block (per 2)

For use with corded and cable operated, curved T60 curtain tracks. Designed to guide the master carrier and cable smoothly into an out of curved hauling sections of T60 curtain track.

T60 Stop Bracket (per 2)

Designed as an anchor for the last hook on a curtain and also as a stopping point for carriers.

T60 Modular Track Clip

The T60 Modular Track Clip is designed for use on site when track sections need shortening. It's easy application means that any track can be altered on site in under 30 minutes. Unlike other bolt on end sections the T60 Modular Track Clip will allow the through put of runners and can be loaded to 75% of the tracks original capacity.

T60 Line Guide (per 2)

For use on any T60 corded overlapped curtain track. The line guide is fitted to the ends of each track where they overlap. The line guide supports the hauling line as it enters and leaves the

T60 Overlap Clip (per 2)

T60 overlap clips are designed to hold two pieces of curtain track at 77mm centres. Used in pairs on all overlapped curtain tracks.

T60 Joint Bolt Set (per 10)

Joint bolts sets are required to join any two pieces of T60 securely together. Supplied with custom made shoulder bolts to ensure that the runner rail lines up perfectly every time.

T60 Line Support (per 2)

A hinged lever arm attached to long straight runs of corded cable track to hold cable sag out of the reach of the curtains. The arm opens to allow the master carrier to pass and then springs in closed behind it to pick up the hauling line again